Troubleshooting guide

7 | C y b e r - R a i n X C I S m a r t I r r i g a t i o n C o n t r o l l e r T r o u b l e s h o o t i n g G u i d e
 Valves Not Functioning. Make sure that the valve has water supplied to it. Then manually “bleed” (open) the valve and make sure water flows.
This is usually done by turning a small knob on the top of the valve (see picture below). Verify that water does flow when the valve is opened. If
it does not, there may be a problem in your irrigation system, or the valve may be faulty. Close the valve. If manually running the valve worked
as expected, manually run the zone using the Cyber-Rain controller for at least two minutes. When functioning normally, the irrigation system
should be supplying 24 volts to the valve while it is active. If 24 volts is being supplied to the valve and the valve is not opening, then the valve is
likely defective. If a valve is determined to be defective either replace it or contact a landscape professional to do so. If 24 volts is not being
supplied to the valve check to ensure the valve wire is correctly connected to the valve harness, and that the valve harness is properly installed
in the controller.