User manual

Cyber Control 2 VI External Control & Triggering
The software first needs to be told which MIDI port to read from. This can be set within
the Software Preferences.
Mapping MIDI controls to the MIDI console
Right click here(1) to create a new console preset, then right click here (2)to load your
midi controller. If your controller is not listed, you will need to build your own console with the console
editor, or map your MIDI controls to a similar console.
You may need to map each control on your MIDI controller to the controls in the MIDI console panel.
(Many of the default consoles are pre-mapped.)
1. Right click the button you wish to link to the MIDI controller
2. Select the MIDI setup tab
3. Either enter the parameters in yourself or select "Auto Setup MIDI" and move the corresponding
fader/dial/button on your controller
Page 82