User manual

Cyber Control 2 V Dealing with Fixtures
To set up ArtNet:
1. Connect your computer to a router with an Ethernet cable
2. ArtNet works on 2.x.x.x IP address range so make sure your computers Ethernet adapter and the
router are set on this address range
3. Connect your lighting fixture or ArtNet-DMX converter to your router
4. Connect the USB-DMX interface to your computer
5. Open Cyber Control 2 and navigate to the output hardware tab inside Software Preferences
6. De-select auto detection and select ArtNet from the combo box
7. Choose a Cyber Control 2 universe from the left combo box and an ArtNet universe on the right
8. If you are using multiple ArtNet universes with an ArtNet-DMX converter, remember to match the
incoming ArtNet universes with the outgoing DMX universes on your converter
The following Suite2 interfaces are compatible with ArtNet:
Suite2-EC - 2 universes
Suite2-FC - 4 universes
Suite2-FC+ - 40 universes*
*ArtNet physically supports up to 40 universes, however if you are planning a project with more than 20
universes, we advise that you contact us first.
7. Printing a Patch
You can print a list of all the fixtures used in your show, their positions and DMX addresses. This can
be useful when setting DMX addresses on the fixtures and can also be sent to clients or equipment hire
companies.
Page 77