User manual

Cyber Control 2 V Dealing with Fixtures
It is possible to limit the highest pan and tilt value of a fixture. This is useful if you have a fixture in the
corner of a room and you don't want the fixture to point at the wall. It can also be used to calibrate a
fixtures moving sequences if not programmed with palettes.
-The pan tilt dialog can be opened by clicking here(1)
-Select your fixtures, then adjust the size of the square on the right
-Use the target to move the fixtures around the room, notice a red line is drawn to help you resize the
square
-You can view your fixtures graphically by deselecting "List View"
-This dialog can also be an effective way to check if the lights are positioned correctly within the fixtures
window by checking the "Solo" radio button
Page 75