Installation Guide

74 | C y b e r - R a i n X C I S m a r t I r r i g a t i o n C o n t r o l l e r U s e r G u i d e
 Estimated GPM: This field is shown when you do not have a flow sensor installed. Here you can manually enter your flow rate for the selected
zone. See the Manually Enter Flow Rates section below for more information.
 Ignore Weather: Checking this option overrides the automatic weather adjustments for the selected zone (it will run the full minutes set in the
schedule for that zone). Enabling this function overrides the water conservation utility of the smart controller for the selected zone, and is not
recommended under normal circumstances.
 Zone Hold: This feature allows you to put designated zones on hold. When activated, the zone will not water for the designated period of time.
To utilize this feature, check the box and set the Zone Hold From and Zone Hold Until fields. (Note: If you wish to put all of a controller’s zones
on hold, use the Hold button in the Run Status panel on the Controller page.)
 Wire Color: This option allows you to enter in the wire color for the selected zone.
 Wire Color Is Striped: This option allows you to enter if the wire color is striped for the selected zone.