Installation Guide

7 | C y b e r - R a i n X C I S m a r t I r r i g a t i o n C o n t r o l l e r U s e r G u i d e
Harness 1 (8, 16, and 24 Zone Controllers)
Harness 2 (16, 24 Zone Controllers)
#
Color
Description
#
Color
Description
1
13
2
14
3
15
4
16
5
Harness 3 (24 Zone Controllers Only)
6
17
7
18
8
19
Harness 2 (16, 24 Zone Controllers)
20
9
21
10
22
11
23
12
24
If your irrigation system uses a master valve or pump (usually to draw water from a source such as a well
or to provide additional water pressure) you will also need to use the master valve lead marked “M”. The
Cyber-Rain controller will provide power to the pump / master valve when a zone is running, and for three
seconds after the zone ends. If you do not have a master valve or pump installed, you will not need this
feature.
Once you have finished wiring the controller, connect the white end of the AC adapter plug to the bottom
of the controller making sure that it is tight and secure. (Note: The AC adapter plug can only be inserted
one way and will snap securely into place when installed correctly.) Then, connect the wall transformer to
a 120VAC wall outlet.
Manual Operation from the Controller Unit
Your Cyber-Rain XCI controller can manually run individual zones directly from the controller unit. After all zone wires have
been installed, you may want to use this feature to check that all zones are working properly. To manually run a zone, press
the LEFT or RIGHT controller arrow keys until the desired zone is displayed. Pressing the select button will activate that zone.
Press the UP or DOWN arrows to increase or decrease the amount of time your Cyber-Rain zone will stay active. Each press of
the UP/DOWN arrow will increase/decrease run times by 30 seconds or, if desired, you can adjust the run time increment from
the Details for Controller panel on the Controller page of the Cyber-Rain Cloud system (see the Controller Page section for
more info). Press the select button again to turn off watering.