Installation Guide

58 | C y b e r - R a i n X C I S m a r t I r r i g a t i o n C o n t r o l l e r U s e r G u i d e
4. Insert: Insert the flow sensor harness into the connector located on the bottom of your controller labeled “FLOW”, making sure that it is properly
aligned. (Note: This is the 2-wire harness on the RIGHT in Pro models.)
5. Setup Parameters: On the Controller page in the Flow Sensor Settings panel, select the Flow Sensor Installed check box indicating that you have
connected a flow sensor to your controller. The Flow Sensor Settings panel will now expand and you can select the type of flow meter that you have.
a. Meter Type: Select this option if you have a “Meter Type” flow sensor (e.g., ARAD/Netafim, Bermad). The Gallons Per Pulse parameter allows you to
calibrate the system to your specific flow sensor. This value is typically found marked on the flow sensor itself.