Installation Guide

54 | C y b e r - R a i n X C I S m a r t I r r i g a t i o n C o n t r o l l e r U s e r G u i d e
The System Alerts traffic light indicates the status of alerts. A green light means no alerts have been triggered. A yellow light means that an alert has
been triggered but Cyber-Rain is continuing to water all zones. A red light generally means that an alert has been triggered and watering has been held
for one or all zones. Details on what alerts have been triggered can be found in the Event Log on the Stats page. Alerts can be cleared by pressing the
Clear Alerts button. The user will receive emails when alerts are triggered and when all alerts have been cleared. (Note: You can opt out of email alerts
by unchecking the email alert boxes in the Site Details panel on the Site page.) For more information on alerts, see the Controller Alerts section.
The Current mA gauge measures the current going through an active valve. If your sprinklers are not running, the current meter should indicate no
current.
The Controller Temperature Gauge indicates the internal temperature of the controller. An alert will be triggered if the controller temperature is outside
of normal range (as shown by the green area). If the temperature is too low (as shown by the blue area) there is a risk of irrigation pipes freezing. If the
temperature is too high (as shown by the red area) there is a risk of controller malfunction. See the Controller Alerts section for more information.
11. Flow Meter Data: If you have an optional Flow Sensor installed and have enabled it in the Flow Sensor Settings panel, the Flow Meter Data panel will be
displayed. This panel has a Flow Rate gauge to show the current flow measured by gallons per minute (GPM). This indicates the rate of water flow going
through an active valve. It also has a digital counter which shows aggregate flow for all zones if a flow meter is installed. It operates similar to an
odometer and can be reset by pressing the Reset Odometer button. See Installing and Using a Flow Sensor in this User Manual for further details.