Installation Guide

48 | C y b e r - R a i n X C I S m a r t I r r i g a t i o n C o n t r o l l e r U s e r G u i d e
This panel expands when you have checked that a flow meter is installed. If a compatible flow sensor is installed and connected to the Cyber-Rain
controller, this feature will monitor the flow of water through the irrigation system and provide under/overflow alerts and automatic watering holds. For
the flow metering to function correctly, the sensor type, calibration settings, fill time, and over/underflow conditions settings must be set. Calibration
settings are specific to flow meters, and typically can be found on the box or through the manufacturer’s documentation. A normal flow rate must be set
for each zone for alerts to be triggered. (Note: Cyber-Rain will stop watering the zone when a high-flow rate has been detected.) Refer to Installing
and Using a Flow Sensor and Controller Alerts sections of this User Manual for more details.
7. Controllers for Site: This panel displays information about all the controllers at the selected site. Clicking a different controller changes the display of
most of the other information on this page, including the Schedule for Controller panel.