Installation Guide

25 | C y b e r - R a i n X C I S m a r t I r r i g a t i o n C o n t r o l l e r U s e r G u i d e
Follow these steps for each controller:
1. Confirm that the serial number of your controller matches the serial number on the Discovery screen (also on the back of the Cyber-Rain controller). If
there is a discrepancy, contact Cyber-Rain Technical Support.
2. Give your controller a name (such as “Cyber-Rain Controller 1” or “Joe’s Cyber-Rain”).
3. Select the total number of zones that you want the controller to manage. Each controller can manage up to 8, 16, or 24 zones (depending on the model).
4. You can set up to four start times for your schedule to begin each day. Select the number that suits your needs, and then provide times for each
watering cycle to begin. Typically one start time is sufficient as Cyber-Rain automatically uses Cycle and Soak for zones on a slope or with dense soil (if
using the recommended horticultural options based on the settings on the Zone page). See the Zone Page and Cycle and Soak sections for more info.
5. Select Register Controller.
6. You will now need to set up your baseline schedule. Read the step-by-step instructions in the following sections.
7. If you have additional controllers to set up, power on the next controller and repeat the above steps (remember to only power on one new controller at
a time during the initial setup).
Additional controller’s schedules can now be accessed on the Controller page by selecting the desired controller in the Controllers for Site panel, and then
viewing the schedule in the Schedule for Controller panel. The zone names and the baseline watering schedule can be edited and the start times for each
watering cycle can also be changed (see the Set Up Your Schedule section for more info).