Installation Guide

20 | C y b e r - R a i n X C I S m a r t I r r i g a t i o n C o n t r o l l e r U s e r G u i d e
Upgrade Existing Installation
If you currently have the Cyber-Rain system installed and are upgrading from the software version to the Cloud version, you will have to put your controller into
“pairing mode” in order for your gateway access point to bind with it. Pairing mode allows the controller to be paired with a new computer:
When in pairing mode, the controller will display a “>”
symbol in the top right corner of its display indicating
that it is ready to be detected by the Cyber-Rain system.
If the controller is not ready to be paired with a
computer, it will display a “|” symbol instead, indicating
that it has already been paired with a computer. Follow
the steps below to reset the controller.
 If your controller is not ready to be paired with a computer (and displays the “|” symbol) and you would like to reset the
controller and put it back into pairing mode, simply press the UP and RIGHT arrows keys on the controller face at the exact
same time and release them after one second. (Note: When resetting a controller, all schedules and settings will be lost on
the controller. Once you reset up your schedule in the Cyber-Rain Cloud system, you can press the Save Schedule button on
the Controller page to resave your settings and schedule to the controller.)
 After a brief “Initialization” message appears, the controller will reboot, and once again will be ready to be paired.
 Once you have fully set up your new Cloud system and controller schedule, and everything is working well for you, you may
uninstall the Cyber-Rain software from your computer if desired.