User Manual

Safety Precautions -

Read

the following before installing or operating

the RackBar Surge (RKBS):

2. The RKBS must only be plugged into a three-wire, grounded outlet on a

circuit protected by a fuse or circuit breaker. Connection to any other type

of power outlet may result in a shock hazard.

3. Do not use extension cords or adapters with this RKBS.

4. Never install a RKBS, or associated wiring or equipment, during a

lightning storm.

5. Check that the power cord, plug, and socket are in good condition.

6. This device features an internal protection that will disconnect the surge

protective component at the end of its useful life but will maintain power to

the load – now unprotected. If this situation is undesirable for the

application, follow the manufacturer’s instructions for replacing the device.

7. CAUTION! To prevent the risk of fire or electric shock, this RKBS

should be installed in a temperature and humidity controlled indoor area

free of conductive contaminants. Do not install this RKBS where

excessive moisture or heat is present..

Installation

Horizontal Installation

Step 1 – Mounting bracket installation

Install the screws (M4 X 6) in holes diagonal from each other.

Step 2 – RKBS Mounting

Install the RKBS using fasteners compatible with the rack.

Vertical Installation with Brackets

Step 1 – Mounting bracket installation

Step 2 – RKBS Mounting

Install the screws (M4 X 6) in holes diagonal from each other.

1. CAUTION! Use ONLY the supplied hardware (including screws, pegs

and cord retainer clips) to attach the mounting brackets. Using different

hardware or improper installations may cause damage that is NOT

covered by this warranty.