Specifications

Message Significance
nnnnn
0 through 32,767; the
remainder obtained
by divid-
ing the
total number of
records
by 32,768.
MODE DIFFERENT
ON MAG TAPE
One
or more records on magnetic
tape contain the same information as
the record being verified against but
of a different mode.
UT FORMAT
INCORRECT
UT INVALID
REQUEST
SETPV4
The request is not correctly
formatted; parameters and/or de-
limiters
are incorrect.
The mnemonic request code is illegal.
SETPV4 error messages are output on the standard list
device. Errors occur
in two phases: statement reading and
statement execution. All errors are fatal; however, some
errors may be delayed
fatal (DF), allowing all statements to
be read and diagnosed. All errors occurring in the statement
execution phase are immediately fatal (IF) and cause an exit
to the job processor •.. A flag is set and checked on entry to
phase two (execution) and, if set, the execution is not
initiated. The message format is:
*****ERROR code
1
2
3
4
5
6
7
8
9
10
5-12
~
IF
DF
IF
IF
DF
IF
DF
IF
IF
IF
Error
An *L control statement must be the first
statement.
megal or wrong format for the control
statement.
An *E must be the last control statement.
Output is attempted with parameters less
than the current position.
Control statements
are out of order
(issued
after an attempt sort).
The maximum number of control
state-
ments is exceeded (1200 maximum).
The first statement is an
*I or an *R
statement and cannot have an asterisk (*)
indicating use of the previous binary.
An attempt is made to access a unit after
a file mark has been encountered.
An *E statement is encountered before an
*0 statement. Outputting must take
place
if there are any *R, *1, *D, or *S
statements in the set.
Mass storage overflow
DSKTAP/DTLP
The DTLP loader function has no diagnostic messages.
DSKTAP messages are as follows:
Message
DISK ERROR ssss
ILLEGAL PARAM-
ETERS SPECIFIED
SECTOR xxxx
WORD - WW DOES
NOT COMPARE.
TYPE C TO CON-
TINUE ORA
CARRIAGE RETURN
TO ABORT
Significance
Disk failed to respond to input/output
commands; ssss is the device status.
The equipment code is not in hexa-
decimal format.
Verification failed; the disk address is
given.
TAPE ERROR ssss Magnetic tape failed to respond to
input/output commands; ssss is
PHYSTB word 12 status.
TURN OFF The computer protect switch must be
PROTECT SWITCH, off to run DSKTAP.
TYPE CARRIAGE
RETURN
MTUP
There are four types of MTUP diagnostic messages: action,
descriptive, serious errors, and warning errors.
Action Messages
Message Significance/Action
*DATA SET NAME: Label processing: output volumes
*INVALID PARM=
"XXX ••• "
*RETYPE PARM:
*MOUNT,OUTPUT,
SCRATCH:
VOLSER=nnnnnn
*VOLSER=nnnnnn:
VOL NOT
EXPIRED USE:
require a data set name if not avail-
able from input.
Action:
DSN="XXXXX"
The characters within quotes are
invalid and may be corrected.
Action: Enter corrected parameter.
Action: Type carriage return, which
implies
that tape is ready, or type
any other character followed
by a
carriage return
to terminate the
initialize function.
Informative tape file just opened with
the specified volume serial number
Action: None
Label processing: output volume
header records
are checked against
the system date.
96769450 A