Specifications
SYSTEM INITIALIZER ERROR CODES
2
This section contains messages encountered when errors
occur during initialization. Five subsections
are
included:
• Initializer error codes. These
are
all
errors
that
are
neither loader nor disk hardware related.
• Initializer loader error codes. These
are
related
directly to problems the loader encounters.
• System disk error messages. These
are
related to
address and
test
data
on
disk writing.
• Initializing input/output device failure message
• Error recovery procedures
The user is referred to section 6 of the
MSOS
Version 5
Reference Manual for the control comments used during
·system initialization.
SYSTEM INITIALIZER CODES
The following defines the system initializer error codes:
Message
ERROR 1
ERROR 2
ERROR 3
ERROR 4
ERROR 5
ERROR 6
ERROR 7
ERROR 8
Significance
Asterisk initiator missing
Number appears
in
the name field
Illegal control
statement
Input mode illegal
Statement
other than
*y
or
*YM
previ-
ouslyentered
Statement other than
*y
previously en-
tered
*y
not entered prior
to
the first
*L
Name appears
in
the number Jield
ERROR
9 Illegal hexadecimal core relocation field
ERROR A Illegal mass storage
sector
number
ERROR B Errol" return from the loader module
ERROR C Not used
ERROR D Not used
ERROR E
ERROR F
96769450 A
Field terminator invalid
More than
120
characters in the control
statement
hS
Message
Significance
ERROR
10
Ordinal name without ordinal number
ERROR
11
Doubly defined entry point
ERROR
12
Invalid ordinal number
ERROR 13 Loader control
statement
out of
order-
Correct order is
L,
LP,
M,
MP
ERROR 14 Data declared during an
*M
load but not
by
the first segment; initialization
re-
started
ERROR 15 Not used
ERROR 16 Irrecoverable mass storage input/output
error
ERROR 17 Irrecoverable loader error;
last
program
loaded was ignored.
ERROR 18 Not used
ERROR 19 Not used
ERROR
20
*S,
ENDOV
4, hhhh not defined before first
*L
ERROR
21
*S,
MSIZV
4,
hhhh not defined before first
*LP or
*MP
ERROR
22
Attempt to load
part
1 core resident into
nonexistent memory
ERROR
~3
The name used
in
the second field of an
*M
control
statement
was not previously
defined as an entry point.
ERROR
24
The entry point, SECTOR, was not defined
at
the
start
of initialization and is not
available to the initializer.
ERROR
25
Illegal partition number in the first field
of an
*MP
statement
or illegal number of
partitions
in
the second field of the
statement.
ERROR
26
An
attempt
was made to load- an
*MP
program when
no
partitioned core table
exists
in
SYSDAT.
SYSTEM INITIALIZER LOADER ERRORS
Significance
LOADER
ERROR 1 Unrecognizable input
LOADER
ERROR 2
Mass
storage overflow
2-1