User's Manual

2. Charging the headset
BH118C has an internal, rechargeable battery which must be fully charged before
used for the first time. It takes you about 2 hours to charge the battery full for the
first time. During charging, the indicator shows a steady red. When the battery is fully
charged, the red light will turn blue. For the later on charging, it takes about 90
minutes.
You can charge the headset either by using the AC travel charger, USB charging cable
or the car charger depending on the package accessories available.
The fully charged battery has power for up to 4 hours of talking time or up to 100
hours of standby time.
When the battery is running out of power, the blue indicator light starts to flash 3
times every 30 seconds. This indicates that the headset needs to be charged as soon
as possible.
3. Switch on or off the headset
To switch on, when BH118C is in off state, press and hold the answer/end key for 4
seconds until the blue indicator light starts to flash for 3 times
To switch off, when BH118C is in on state, press and hold the answer/end key for 4
seconds until the red indicator light flashes for 3 times.
4. Pair the headset with a compatible phone
Pairing is the process of establishing encrypted link between BH118C and Bluetooth
devices.
Step-1 The headset must be powered off before you begin to initiate the paring.
Step-2 press and hold the answer/end key for 7 second until the blue and red light
flash alternatively. The headset is now in paring mode.
Step-3 Activate the Bluetooth feature on the phone, and set the phone to search for
Bluetooth devices. Check the user guide of your phone for instructions.
Step-4 Select the headset (BH118C) from the list of found devices.
Step-5 When asked the PIN code, please enter “0000” to pair and connect the
headset to your phone. In some phones you may need to make the connection
separately after pairing. See the user guide of your phone for details.
If the pairing is successful, the headset enters idle state and blue light will flash
flashes 1 time every 5 seconds. The headset’s name appears in the phone menu
where you can view the currently paired Bluetooth devices.
You only need to pair the headset with your phone once.
Troubleshooting
If you cannot connect the headset to your phone, do as follows:
· Ensure that the headset is charged, switched on, paired with and
connected to your phone.
· Ensure that the Bluetooth feature is activated on your phone.