Owner Manual

42339 rev A 11-06-19
6
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370,
6590188, 6976052, 6965815, 7030343, 7,417,834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and
domestic applied for and pending. All material copyright of Balboa Water Group.
In order for the spa to heat, a pump needs to circulate water through the heater. The pump that performs this function is
known as the “primary pump.”
The primary pump can be either a 2-Speed Pump 1 or a circulation pump.
If the primary pump is a 2-Speed Pump 1, Ready Mode (indicated by ) will circulate water periodically, using Pump 1
Low, in order to maintain a constant water temperature, heat as needed, and refresh the temperature display. This is known
as “polling.”
Rest Mode (indicated by ) will only allow heating during programmed filter cycles. Since polling does not occur, the
temperature display may not show a current temperature until the primary pump has been running for a minute or two.
Circulation Mode (See Page 4, under Pumps, for other circulation modes)
If the spa is configured for 24HR circulation, the primary pump generally runs continuously. Since the primary pump is
always running, the spa will maintain set temperature and heat as needed in Ready Mode, without polling.
In Rest Mode, the spa will only heat to set temperature during programmed filter times, even though the water is being
filtered constantly when in Circulation Mode.
Ready-in-Rest Mode
appears in the display if the spa is in Rest Mode and “Jets” is pressed. It is assumed that the spa is being used and
will heat to set temperature. The primary pump will run until set temperature is reached, or 1 hour has passed. After 1 hour,
the System will revert to Rest Mode. This mode can also be reset by entering the Mode Menu and changing the Mode.
Mode – Ready and Rest
Sub-Menu Detail – MODE – Ready and Rest
Ready Mode will allow the spa to Poll and determine a need for heat. The panel will maintain a “current” temperature display.
Rest Mode will not Poll and will only heat during filter cycles. The panel will not display a current temperature at all times.
The Main Screen will display RUN PUMP FOR TEMP if the primary pump has not run for over 1 hour.
The Main Screen will display normally during Filter Cycles or when the spa is in use.
If the primary pump has been off for an hour or more, when any function button, EXCEPT Light, is pressed on the panel,
the pump used in conjuncton with the heater will run so that temperature can be sensed and displayed.
1 Hour
04-11-09
Press Menu/Select
repeatedly until MODE
appears in the LCD.
Main Screen
Main Screen
Main Screen
To Set
Toggle between Ready (indicated by ) and Rest (indicated by ).
Pressing
Menu/Select when the display is toggled will go to Main Screen.
To next item in
Main Menu
If not toggled
*****
Waiting a few
seconds reverts to
original settings
MODE
RUN
PUMP
TEMP
----
Indicates Flashing or Changing Segment
Key
A temperature button, used for “Action”
Menu/Select button
Indicates Alternating or Progressive Message - every 1/2 second
Waiting time that keeps the last change to a menu item.
Waiting time (depends on menu item) that reverts to original setting and
ignores any change to that menu item.
*****
Sub-Menu Detail – MODE – Ready-in-Rest
04-11-09
Main Screen
Press “Jets” button
Main Screen