Use and Care Manual

13
VARIABLE-SPEED TRIGGER SWITCH – cont’d
LED WORKLIGHT
The LED worklight (3) will automatically turn ON
when the trigger switch is squeezed (Fig. 8). It
will automatically turn OFF when the trigger
switch is released.
TWO-SPEED GEAR BOX SWITCH
The two-speed gear box switch is located on the
top of the drill housing. Set the speed-control
switch to the desired speed before starting the
drill. Slide the speed-control switch BACK
(Fig. 9a) for low-speed operation. Slide the
speed control-switch FORWARD (Fig. 9b) for
high-speed operation.
NOTES:
a) Use low-speed setting for drilling large
holes and for driving screws.
b) Use high-speed setting for drilling smaller
holes.
c) Do NOT change the speed-control switch
pos
ition while drill is turned ON. Damage to
the gears may result.
INSTALLING DRILL BITS
WARNING: Never hold the chuck body
with one hand and use the drill power to
rotate the drill body to loosen or tighten bits.
Serious injury may result.
ASSEMBLY AND OPERATING
!
Fig. 7
Fig. 8
Fig. 9a
Fig. 9b
This drill/driver is equipped with a double sleeve
keyless chuck.
1. To open the keyless drill/driver chuck,
grasp and hold the chuck collar (1) with
one hand (Fig. 8). Rotate the chuck body
(2) with the other hand in a counter
clockwise direction (3) until the chuck jaws
(4) open wide enough to accept the bit (5).
2. Insert the bit into the chuck the full length
of the jaws. Raise the front of your
drill/driver slightly to prevent the bit from
falling out of the chuck jaws.
3. Tighten the chuck jaws onto the bit by
turning the chuck body in a clockwise
direction.
NOTE: Make sure the bit is properly aligned in
the jaws and NOT at an angle. An improperly
aligned bit could be thrown from the chuck when
drill/driver is started. Make sure flat sides of the
screwdriver bit are being grasped by
the chuck
jaws.
4. Finish tightening the chuck jaws by holding
the chuck collar with one hand and firmly
tightening
the chuck body by rotating it in a
clockwise direction.