Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Zephyr
™
-PRIN-2830-0620
9
Step 7 Installing the Door Panels
Installing the Door Panels may be easier if you have
someone assisting you. Always wear gloves and
safety glasses whenever handling glass.
Note: Take extra care in handling the Glass Panels.
DO NOT allow the corners of the Panels to strike
the tub/tile, each other, any hard surface, wall or
floor, as these actions may cause damage and
the tempered glass will shatter. Keep the corner
protectors on the Glass during installation.
A. Hold the Inside Door Panel so that the Wheels
are facing away from you. Standing outside and
facing the shower enclosure, lift the Inside Door
Panel up and over the Curb and then insert the
Top Rail Wheel Assemblies up into the Header
and gently set the Wheels into the rear track of the
Header. Make sure that the Panel rolls freely.
B. If someone is assisting you, have them hold
the Inside Door Panel back, out of your way for
this step. Hold the Outside Door Panel so that the
Wheels are facing towards you. Standing outside
and facing the shower enclosure, use the index
fingers of both hands to carefully push the Inside
Door Panel back and out of the way as you lift
the Outside Door Panel up and over the Curb and
then insert the Top Rail Wheel Assemblies up and
into the Header (See Figure 10). DO NOT let the two
Panels strike one another. Gently set the Wheels
into the front track of the Header.
C. Carefully let the Inside Door Panel ease back
into position. Make sure both of the Panels roll
freely.
Push with
index finger
Tub Sill/
Shower Dam
Figure 10
Inside
enclosure
Outside
enclosure
Header
(#1)
Curb (#3)
Outside Door Panel
(#10)
Inside Door
Panel (#11)