Installation Instructions
Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: 661.257.1177 Fax: 661.257.4907 | CwDoors.com
Zephyr
™
-PRIN-2830-0620
8
Outside
enclosure
Outside
Door
Panel
Adjustable
Cam
(#9g)
Ca m Wr e n ch
(#9h)
Panel Hanger
Assembly (#9)
Figure 8
D. Repeat with the second Clamp Assembly, and
insert the second Bushing into the other hole in the
Outside Panel.
E. Place two Gaskets over the top edge of the
Outside Panel, with the holes in each Gasket
aligned with a holes in the Outside Panel and the
larger hole facing into the shower.
F. Loosen the screws on two of the T-Brackets so
you can fit them over the top of the Gaskets on the
Door Panel with the holes aligned (See Figure 7).
G. Use a phillips screwdriver to tighten the screws
and attach the two T-Brackets to the Door Panel
over the two Gaskets. Do not over tighten.
H. Insert an Adjustable Cam through the opening
of one of the T-Bracket Housings and into the Door
Panel (See Figure 8).
I. Using the 2-Pin Cam Wrench, turn the Adjustable
Cam until it clicks into place inside the Door Panel.
J. Once the Adjustable Cam has clicked into place,
use the Cam Wrench to turn it in increments to
adjust the level of the Door Panel. Note: You can
adjust the alignment further using the Adjustable
Cam and Cam Wrench in Step 7G after the Door
Panel is hung.
K. While holding the Adjustable Cam in place with
the Cam Wrench, insert a #10-32 x 3/4 Hex FH screw
through the Cam Wrench into the Adjustable Cam
and then use an allen wrench to tighten the screw.
L. Repeat Steps 6H-6J over the other Gasket on
top of the Outside Door Panel.
M. Attach the remaining two Clamp Assemblies
to the top of the Inside Door Panel, with rollers
facing into the enclosure (See Figure 9). Do not over
tighten.
N. Reattach the Adjustable Cams as in Step 6H-K.
Inside
enclosure
Figure 7
Outside Door
Panel (#11)
Gaskets
(#9f)
Panel Hanger
Brackets (#9a)
L-Bracket
(#9i)
L-Bracket
(#9i)
Figure 9
Inside Door
Panel (#12)
Panel Hanger
Assembly (#9)