Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Zephyr
™
-PRIN-2830-0620
7
Figure 5b
Header
(#1)
Wall Jamb
Right (#2R)
mechanisms, inserting them into on the other
side of the Header, with the “catch” of each Soft
Close positioned toward the end of the Header.
D. Attaching the Header to the Wall Jamb
The Zephyr
™
comes with a positive snap-lock feature
which eliminates the need for screws to hold the
Header in place. Spread the Header sides slightly as
you pull it down onto the Wall Jambs and it snaps
and locks in place. You should be able to hear and
feel when it solidly locks in place (See Figure 5b).
Step 6 Attaching the Clamp Assembly
A. Locate the Outside Door Panel.
B. Locate two of the four pre-assembled Clamp
Assemblies, each consisting of T-Bracket Housing,
L-Bracket, Adjustable Cam, Bushing, Cam Cover
and five screws (See Figure 6).
Panel Hanger
Assembly (#9)
Outside Door Glass Panel Clamp Assembly
View from outside enclosure
T-Bracket
Housing
(#9d)
L-Bracket
(#9i)
Gasket
(#9f)
Bushing
(#9e)
Adjustable
Cam
(#9g)
Cam
Cover
(#9j)
Figure 6
Glass Thickness Gasket
1/4” (6mm) Thick
5/16” (8mm) Thin
C. Locate two of the four Gaskets.
Note: There are two Glass thicknesses available, 1/4”
(6mm) or 5/16” (8mm). If you purchased 5/16” (8mm)
Glass locate the 5/16” (8mm) package that includes
the thinner Gaskets and Center Guide to be used with
your unit.
B. Remove the Cam Cover from one pre-assembled
Clamp Assembly by loosening the screw. Keep the
screw with the Cam Cover and put them aside
together.
C. Remove the Adjustable Cam with Bushing,
and insert the Bushing into one of the holes in the
Outside Panel.