Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Zephyr
™
-PRIN-2830-0620
4
CAUTION: Do NOT cut tempered glass or allow
the corners of the panels to strike the tub/tile,
each other, any hard surface, wall or floor, as these
actions may cause damage and the tempered glass
will shatter. Keep the corner protectors on the glass
during installation. Using safety glasses and safety
gloves is highly recommended.
Tool checklist (included):
• 2-Pin Cam Wrench
Tool checklist (not included):
• Phillips screwdriver
• Level
• Electric drill
• 1/8” drill bit (for fiberglass stall)
• 3/16” masonry drill bit (for tile stall)
• Pencil
• Fine metal file
• Miter box & hacksaw with 32 tooth blade
• Caulking gun and clear tub/tile silicone
• 1/4” open end wrench
• Wire cutters
• Tape measure
• Painters tape
• Safety glasses and safety gloves
Step 1 Preparing your opening
A. Before you remove the existing enclosure and
all its parts, check that your newly purchased
enclosure is the correct size (See Figure 1).
1. Measure the finished opening width at top
(a) and bottom (b). Your new tub or shower
enclosure should have a width equal to or
greater than the largest measured width of
your opening.
2. Measure the finished opening height from
the tub or shower sill (c) to the top of your tub
or shower surround/tile (d). The height of your
tub or shower enclosure should not exceed the
top of your tub or shower surround/tile.
B. After determining that your newly purchased
enclosure is the correct size, remove the existing
enclosure and all its parts.
C. Remove all screw anchors from the wall.
D. Clean silicone sealant or caulking and any
other contaminants from tub/shower and wall
surfaces. Fill any remaining holes with silicone for
waterproofing.
Note: Unless otherwise stated, views and directions
given in these instructions – left, right, front, back,
etc. – are from outside the enclosure, facing the tub/
shower.
KNOW YOUR WIDTH
KNOW YOUR HEIGHT
• Measure the finished opening width at top A.
and bottom B.
• Use the measured width to select the appropriate
tub/shower enclosure width.
• Select the tub/shower that has a width that is equal or
greater than the largest measured width of your opening.
• Measure the finished opening height from the tub or shower curb
C. to the top of your tub or shower enclosure or tile D.
• The tub or shower height should not exceed our noted
model’s height.
SHOWER
Height
A.
B.
C.
TUB
A.
B.
D.
Height
C.
D.
KNOW YOUR WIDTH
KNOW YOUR HEIGHT
• Measure the finished opening width at top A.
and bottom B.
• Use the measured width to select the appropriate
tub/shower enclosure width.
• Select the tub/shower that has a width that is equal or
greater than the largest measured width of your opening.
• Measure the finished opening height from the tub or shower curb
C. to the top of your tub or shower enclosure or tile D.
• The tub or shower height should not exceed our noted
model’s height.
SHOWER
Height
A.
B.
C.
TUB
A.
B.
D.
Height
C.
D.
Tub
Shower
a
b
c
d
Figure 1
a
b
d
c
Height
Height
Width Width