Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Zephyr
™
-PRIN-2830-0620
11
Step 10 Installing the Towel Bar and
Knob with Recessed Finger Pulls
Step 9 Adjusting the Door Panels
Before you begin, refer to Figure 12 to determine
the correct orientation of hardware for your own
installation. The Inside Door Panel with Knob will slide
to the wall nearest the shower head. The Outside Door
Panel with Towel Bar will slide to the opposite wall.
Figure 12
A. Loosen the Adjustable Cam screw on the side of
a Door Panel that will need to be raised to make the
Door Panel level.
B. Use the Cam Wrench to turn the Adjustable
Cams on each Clamp Assembly until both Door
Panels are level.
C. After adjusting, retighten each Adjustable Cam
screw using an allen wrench through the Cam
Wrench.
D. Re-attach the Cam Cover over each of the four
Adjustable Cam using a Cam Cover screw.
E. Securing the Soft Close Mechanism
1. Slide both Door Panels to one end of the
Header, engaging the Soft Close catch in each
track. Move the Door Panels engaged with Soft
Close as close as possible to the Wall Jamb.
2. Using the screwdriver, tighten the screw in
each Soft Close plate to hold it in place near the
Wall Jamb on that side. Do not over tighten.
3. Move the Door Panels to the other end of
the Header, engaging the other two Soft Close
mechanisms, to the other Wall Jamb where you
want the Door Panels to stop. Tighten the screw
in each Soft Close plate to hold it in place on
that side.
4. Make sure both Door Panels roll all the way
from one end of the Header to the other, each
stopping softly at a secure Soft Close mechanism
at the wall.
Shower head
on the left
Shower head
on the right
A. Locate the Towel Bar Kit parts for the Outside
Door including Towel Bar, two Towel Bar Adapters,
two Recessed Finger Pulls, four Washers and two
Bushings. Refer to Figure 11 to help identify these
parts for your hardware style.
B. Installing the Towel Bar to the Outside Panel
1. Slide both Door Panels to the side opposite the
shower head. Now slide the Outside Door Panel
5-6” toward the shower head. This will give you
clearance to perform the next step.
2. Keeping the Towel Bar Adapters attached to
the ends of the Towel Bar on both sides, detach
both Recessed Finger Pulls, keeping one Washer
and the Bushing on it.
3. Insert the Recessed Finger Pull with one
Washer and Bushing through the hole in the
Outside Door Panel, so that the end sticks out
on the front side.
4. Place the other Washer over the exposed end
of the Recessed Finger Pull, and screw it into one
end of the Towel Bar “finger tight.”
Note: The Solana Towel Bar comes with screws
which go through the Recessed Finger Pulls to attach
them to the Towel Bar. Tighten screws with phillips
screwdriver.
5. Repeat Step B, 2-4 through the other hole of
the Outside Door Panel to complete installation
of the Towel Bar (See Towel Bar Assembly,
Figure 13).