Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Surfliner
™
-PRIN-2820-0620
9
Figure 12
Anti-Jump
(#9d)
Header
(#1)
Inside Panel
Hanger
Bracket (#9a)
Anti-
Jump
(#9d)
Header
(#1)
6. Make sure the Inside Door Panel is level
and rolls freely all the way from one end of the
Header to the other.
Hex Key
Figure 11
Adjustable Cam
(#bb)
Hex Key
Inside Glass
Panel (#15)
Header
(#1)
Inside Panel
Hanger
Bracket
(#9)
Hanger
Bracket
(#9a)
Step 8 Installing the Center Guide
Figure 13a
Rotate Center
Guide (#16)
under
lip
Curb
(#3)
WARNING! DO NOT ATTEMPT TO LOCK THE CENTER
GUIDE IN PLACE UNTIL YOU ARE READY TO INSTALL
IT! Once the Center Guide is in place the shower Door
Panels will be extremely difficult to remove, and
adjusting or removing the Center Guide will be nearly
impossible.
Note: There are two Glass thicknesses available; 1/4”
(6mm) or 5/16” (8mm).
A. Locate your Center Guide(s). If you received two
Center Guides, select the color that best matches
your finish.
B. Make sure that the surface of the Curb is
completely clean of oil, dust, debris or other
contaminants. With a tape measure, measure from
Wall Jamb to Wall Jamb and, with a pencil, mark
the center point of the Curb on the inside edge of
the Curb or lightly on the tub sill/shower dam or
tile where it will be visible and easy to remove.
Remember, you will want to be able to see the
pencil mark after you insert the Center Guide into
the groove in the Curb so that you can center the
Center Guide.
C. Remove the corner protectors from the Glass.
D. Slide Door Panel to one side. Peel the paper
backing off the two-way tape on the bottom of
the Center Guide. Without letting the adhesive
tape touch the Curb, carefully insert the front edge
of the Center Guide into the groove on the Curb
(See Figure 13a).
Glass Thickness Center Guide
1/4” (6mm) HARD-2000
5/16” (8mm) HARD-2005
of the Adjustable Cam to turn it. This moves the
Panel up or down in the Hanger Assembly (See
Figure 11).
4. Tighten the screw in each Adjustable Cam
with the Hex Key after aligning the Inside Panel.
Do not over tighten.
5. After the Inside Panel is aligned and the
Adjustable Cam screws are tightened, insert
the Anti-Jump into the hole in the Inside Panel
Hanger Bracket as shown in Figure 12 and tighten
with the smaller Hex Key.