Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Surfliner
™
-PRIN-2820-0620
8
Step 7 Installing the Inside Panel
A. Attaching the Inside Panel Hanger Assembly
1. Insert Cam Bushings into the hole at the top
of the Inside Glass Panel.
Note: There are two Glass thicknesses available; 1/4”
(6mm) or 5/16” (8mm). If you purchased 5/16” (8mm)
Glass locate the 5/16” (8mm) package that includes
the thinner Gaskets to be used with your unit.
2. Place a Gasket over the end of the Adjustable
Cam and insert the Adjustable Cam through the
hole from the smooth side of the inside Glass
Panel.
3. Place another Gasket on the Inside Panel
Hanger Bracket and attach the Inside Panel
Hanger Bracket with Wheels to the Adjustable
Cam (See Figure 9). Insert a #10-32 x 3/4” HFH
screw through the Cam and tighten with the Hex
Key. Do not over tighten.
Note: View is from inside of tub/shower or back of
glass
4. Locate four Ball Bearing Wheels, and the
four#8-32 x 1/4” HFH Screws. Using the phil;ips
screwdriver, attach two wheels to Inside Panel
Hanger Bracket.
5. Repeat Step 7A 1-4 with second Inside Panel
Hanger Assembly through the other hole at the
top of the Inside Panel.
B. Hanging the Inside Panel in the C-Rail Header
Installing the Glass Panels may be easier if you
have someone assisting you. Always wear gloves
and safety glasses whenever handling glass.
Note: Take extra care in handling the Glass Panels.
DO NOT allow the corners of the Panels to strike
the tub/tile, each other, any hard surface, wall or
floor, as these actions may cause damage and
the tempered glass will shatter. Keep the corner
protectors on the Glass during installation.
1. Remove the Inside Panel Anti-jump Screw
from Inside Panel Hanger Bracket.
2. Hold the Inside Door Panel so that the Wheels
are facing you. Standing outside and facing
the tub/shower enclosure, lift the Inside Door
Panel up and over the Curb and then insert the
Inside Panel Hanger Brackets up into the Header
and gently set the Wheels into the track of the
Header. Make sure the Panel rolls freely (See
Figure 10).
3. The Inside Door Panel can be adjusted by
loosening the screw in either of the Adjustable
Cams, and inserting the Hex Key into the side
Figure 9
Inside Panel Hanger Assembly (#7)
Inside Panel
Hanger Bracket
(#9a)
Adjustable
Cam (#bb)
Hex Key
#10-32 x 3/4”
HFH Screw
(#aa)
Gaskets
(#cc)
Cam
Bushing
(#dd)
Figure 10
Inside
enclosure
Header
(#1)
Inside Glass
Panel (#15)
Inside Panel
Hanger
Assembly
(#9)
Adjustable
Cam (#bb)
Outside
enclosure