Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Surfliner
™
-PRIN-2820-0620
12
Step 10 Installing the Towel Bar and
Knob with Recessed Finger Pulls
Before you begin, refer to Figure 17 to determine the
correct orientation of hardware for your installation.
The Inside Door Panel with Knob will slide to the wall
nearest the shower head. The Outside Door Panel
with Towel Bar will slide to the opposite wall.
Figure 17
Shower head
on the left
Shower head
on the right
A. Installing the Towel Bar to the Outside Panel
1. Locate the Towel Bar Kit parts for the Outside
Door including a Towel Bar, two Towel Bar
Adapters, two Recessed Finger Pulls, four
Washers and two Bushings. Refer to Figure 18-19
to help identify these parts for your hardware
style.
2. Slide both Door Panels to the wall opposite
the shower head. Now slide the Outside Door
Panel 5-6” toward the shower head. This will
give you clearance to perform the next step.
3. Keeping the Towel Bar Adapters attached to
the ends of the Towel Bar on both sides, detach
both Recessed Finger Pulls, keeping one Washer
and the Bushing on the Recessed Finger Pulls.
4. From inside the shower, insert the Recessed
Finger Pull with one Washer and Bushing
through the hole on the Outside Door Panel, so
that the end sticks out from the front side of the
Glass Panel.
5. Place the other Washer over the exposed end
of the Recessed Finger Pull, and screw it into one
end of the Towel Bar “finger tight.”
Note: The Solana
™
Towel Bar comes with Screws
which go through the Recessed Finger Pulls to attach
them to the Towel Bar. Slightly tighten the Screws
with a phillips screwdriver.
6. Repeat Step B, 2-4 through the other hole of
the Outside Door Panel to complete installation
of the Towel Bar (See Towel Bar Assembly,
Figure 18).
7. Tighten both sides of the Towel Bar/Recessed
Finger Pull.
tighten with the Hex Key. Do not over tighten.
4. Repeat Step 9, B3 with second Outside Panel
Hanger Assembly. This will secure the Outside
Panel to the Header. Do not over tighten the
screw.
C. Adjusting the Outside Panel
The Outside Door Panel can be adjusted like the
Inside Door Panel, by loosening the screw in each
Adjustable Cam, from inside the enclosure.
1. Insert the Hex Key into the side of the
Adjsutable Cam to turn it and move the Outside
Panel up or down in the Assembly (See Figure 16).
2. Tighten the screw in each Adjustable Cam
after adjusting the Outside Door Panel. Do not
over tighten
3. Carfully make sure the Outside Door Panel
rolls freely all the way from one end of the
Header to the other, bi-passing the Inside
Door Panel.