Installation Instructions
Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: 661.257.1177 Fax: 661.257.4907 | CwDoors.com
Surfliner
™
-PRIN-2820-0620
11
B. Hanging the Outside Panel on the Header
Installing the Door Panels may be easier if you have
someone assisting you. Always wear gloves and
safety glasses whenever handling glass.
Note: Take extra care in handling the Glass Panels.
DO NOT allow the corners of the Panels to strike
the tub/tile, each other, any hard surface, wall or
floor, as these actions may cause damage and
the tempered glass will shatter. Keep the corner
protectors on the Glass during installation.
1. Remove Outside Panel Anti-Jump/Soft
Close Catch.
2. Hold the Outside Door Panel so that the
Wheels are facing away from you. Standing
outside and facing the tub/shower enclosure,
lift the Outside Door panel up and over the Curb
and then lower the Outside Panel Assembly
over the Header and at the same time ensure
the bottom of the Outside Door Panel is inserted
into the Center guide. make sure the Panel rolls
Outside
Panel
Hanger
Assembly
(#10)
Inside
Panel
Hanger
Assembly
(#9)
44mm
Wheel
(#10b)
Outside
Panel
Center Guide
(#16)
Header
(#1)
End View
Figure 15
freely (See Figure 15).
Note: If you have a Soft Close installed in your Header,
you will need to move the Soft Close mechanisms
inside the Header all the way to the ends (two on each
end of the Header track), so they are out of the way
when attaching the Soft Close Catches.
3. Hook the Anti-Jump/Soft Close Catch under
the Header on one Outside Panel Bracket (See
inset, Figure 16). Attach the Soft Close Catch
to the 44mm Wheel with the #8-32 HFH screw
Adjustable
Cam (#bb)
Hex Key
Header
(#1)
Outside
Panel Hanger
Assembly
(#10)
Outside Panel
Anti-Jump/
Soft Close
Catch (#10c)
Outside Glass
Panel (#14)
Figure 16
Inside
enclosure
Outside
enclosure
Hex Key