Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Model 750-PRIN-1280-0220
8
Step 12 Installing the Handles
A. Locate two Handles and two #6 x 1/4” “B”-Point
Screws.
B. Standing in the shower, with the curved part
of the handle facing into the shower, position the
Handle midway on the frame of the Inside Door
Panel (as measured from the bottom of the Panel),
on the edge nearest the Wall Jamb near the shower
head (See Figure 11). Use a #6 x 1/4” “B”-Point
Screw to attach the Handle to the Side Rail of the
Inside Door Panel.
C. Repeat these steps for the other side of the
Inside Door Panel.
Inside
of shower
Position Handle
midway on Door Panel
Handle:
Curved part
faces into
shower
Handle (#14)
Caulk where:
• Wall Jambs and wall meet
• Curb and Wall Jambs meet
• Curb and shower sill meet
Step 13 Silicone sealing the enclosure
Using clear silicone seal along the interior and
exterior edges of the Header, Wall Jambs and Curb
(See Figure 12).
Note: Silicone sealant must cure before you use your
new enclosure. Silicones may vary. Please follow
curing instructions on the tube.
Figure 11
Figure 12