Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Model 750-PRIN-1280-0220
5
Step 4 Caulking and installing the Curb
A. Apply silicone along the underside of the Curb
as shown in Figure 5. Only apply enough silicone to
just barely overfill the grooves.
Figure 5
Caulk
Curb (#2)
Turn Curb (#2) over before
installing on the sill
Step 5 Installing Wall Jambs
and Bumpers
A. With the narrow leg of each Wall Jamb toward
the inside of the shower enclosure, install the Wall
Jambs by setting each one down over the Curb and
re-aligning the holes of each Wall Jamb with the
holes you drilled in each wall (See Figure 6).
Figure 6
B. Use two #8 x 1-1/2” FH SMS Screws, top and
bottom, to secure each Wall Jamb to the wall.
C. Use two #8 x 1-1/2” PH SMS Screws to secure
Wall Jamb Bumpers in the center hole of each Wall
Jamb.
D. Tighten all screws.
In order to install the Panel Locator you must first
determine which wall the shower head is on (See
Figures 5a and 5b). If the shower head is on the right
wall, refer to Figure 5a to position the Panel Locator.
If the shower head is on the left, refer to Figure 5b.
Attach the Panel Locator to the edge of the Wall
Jamb facing the inside of the shower, on the shower
head side, as shown.
Step 6 Installing the Panel Locator
Figure 5b
Figure 5a
Wall
Jamb (#3)
Wall Jamb Bumper (#11)
Panel Locator (#24)
Shower head
and controls
right side
Shower head
and controls
left side
Wall
Jamb (#3)
Wall Jamb Bumper (#11)
Wall
Jamb (#3)
Wall
Jamb (#3)
Wall Jamb Bumper (#11)
Wall Jamb
Bumper (#11)
Panel
Locator (#24)
Shorter leg of Wall Jamb
faces into inside of shower
Curb
(#2)
B. Using the location marks install the Curb and
seal both ends at the wall with silicone.