Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Model 750-PRIN-1280-0220
2
CAUTION: Do not cut tempered glass or allow the
corners of the panels to strike the tub/tile, each
other, any hard surface, wall or floor, as these
actions may cause damage and the tempered glass
will shatter. Keep the corner protectors on the glass
during installing. Using safety glasses and safety
gloves is highly recommended.
Parts check list:
Qty. Part Description
1 Header - #750 (approx. 1” oversized)
1 Curb (approx. 1” oversized)
2 Wall Jamb
1 Guide
1 Outside Door Panel
1 Inside Door Panel
4 Roller
2 Wall Jamb Bumper
1 Towel Bar
2 Towel Bar Bracket
2 Handle
6 #6 x 1/4” “B”- Point Screw
2 #8 x 1/2” PH B PT Screw
4 #8-32 x 3/8” HWH Screw
4 #8 x 1-1/2” FH SMS Screw
2 #8 x 1-1/2” PH SMS Screw
1 #6 x 3/8” PH SMS Screw
6 Screw Anchor
Before beginning assembly of the product, make
sure all parts are present. Compare parts with the
checklist and package contents list. If any parts are
missing or damaged, do not attempt to assemble the
product. Contact our Customer Service department
with any questions or concerns you may have about
this product at 661.257.1177.
Tool check list (not included):
• Phillips screwdriver
• Level
• Electric drill
• 1/8” drill bit (for fiberglass stall)
• 3/16” masonry drill bit (for tile stall)
• Pencil
• Hammer
• Fine metal file
• Miter box and hacksaw with 32 tooth blade
• Caulking gun and clear tub/tile silicone
• 1/4” open end wrench
• Wire cutters
• Tape measure
• Painters tape
• Safety glasses and gloves
Congratulations on purchasing your new Cw
®
tub/
shower enclosure. Now that you have opened the
package, we want you to verify that you have all the
necessary hardware supplied with your enclosure.
Please read and understand these instructions in
their entirety prior to assembly, installation and
operation.
DO NOT REMOVE your old shower door until you
check that your new shower door kit is the right size
for your shower and that all the proper parts are in
the box or hardware bag.
Use a level to check that the tub (sill/shower dam) is
reasonably level – not more than 1/4” out of level from
side to side. If it is out of level more than that, you may
want to consider ordering a custom-mitered fill that fits
under the Bottom Track/Curb. This will level the Bottom
Track/Curb correctly. In the absence of leveling the
Bottom Track/Curb with a mitered fill, and depending
upon how badly your tub is out of level, the panels may
not stay in a closed position. Instead, the panels may
roll downhill, causing one of the doors to open.
DO NOT use a razor blade to cut open the paper
wrapping as you may scratch the contents. In the box
you should find the following parts: