Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Model 650/660-PRIN-1275-0220
7
Thank you for making Cw
®
a part of your home.
For additional inspiration and to learn more
about our extensive line of products, we invite
you to visit our website at CwDoors.com.
Step 7 Installing the Handles
A. Locate the Outside Handle, Inside Handle (with
holes) and the two #8 x 1-1/2” FH SMS Screws.
B. Use the #8 x 1-1/2” FH SMS Screws to attach
the Handles to the Pivot Strike Rail. Screw heads
should be INSIDE the shower.
Step 8 Installing the Sill Strip
A. Locate the Sill Strip. Do not remove the backing
from the two-way tape on the Sill Strip at this
time.
B. From the outside of the shower enclosure
insert the Sill Strip to meet the Adjustable Pivot
Jamb Bracket. Cut the other end of the Sill Strip
straight to fit up against the Fixed Jamb with
Magnetic Jamb Seal (See Figure 8).
Step 9 Silicone Sealing the Enclosure
Step 10 Cleaning the Door Panels and
Shower Unit
Figure 8
Outside Shower
Sill Strip
C. Make sure that the top surface of the shower
sill is completely clean of oil, dust, debris or
other contaminants. Peel off the backing on the
adhesive tape on the bottom of the Sill Strip and
press it into place on top of the shower sill.
Using a caulking gun and clear silicone, seal inside
your shower enclosure in the following areas:
If your unit has the benefit of CwShield™ Glass
Protection, following the detailed maintenance
instructions below will ensure many years of
satisfaction.
• After each use: Use a small plastic bowl or pitcher
(a handheld shower sprayer will also work) to
carefully pour clean water along the top edge
of the glass in a stream as you move across the
panel, being careful not to pour the water out
through any gaps that may exist in the enclosure.
The majority of the soapy residual water will drain
off. Use a small hand towel to pat dry the few
remaining droplets.
• Once a month: Each month after use, wet a
nylon “light scrubber” and go over the wet glass,
rubbing in a circular motion over all the glass. You
should feel any “sticky” places return to “slick”
again. Then carefully pour the water along the top
edge of the glass in a stream as you move across
the panel, just as you do after each use.
• Never use harsh chemicals, as they will harm the
CwShield™ Protective Coating.
• For units without CwShield™ Glass Protection,
we recommend cleaning the glass and enclosure
hardware with a mild, non-abrasive cleaner
designed for mirror and/or glass. Avoid using
scouring cleansers as this will scratch and mar the
beautiful finish on the enclosure.
• At the bottom of the Adjustable Pivot Jamb inside
where the Sill and Adjustable Pivot Jamb Bracket
meet.
• Inside of the shower from the top of the Adjustable
Pivot Jamb, down to the sill of your opening.
• Inside of the shower from the top of the Fixed
Jamb with Magnetic Jamb Seal, down to the sill of
your opening.
Note: Silicone sealant must cure before you use your
new enclosure. Silicone curing will vary. Please follow
curing instructions on the tube.