Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Model 650/660-PRIN-1275-0220
4
Adjustable Pivot
Jamb Bracket
(#2)
Pivot
Bushing
(Bottom) (#12)
Adjustable
Pivot Jamb Bracket (#2)
Figure 3
Adjustable Pivot
Jamb Bracket (#2)
Pivot
Bushing
(Bottom) #12)
Adjustable
Pivot Jamb Bracket (#2)
Figure 3a
Model 650 Pivot Jamb (#1)
Model 660 Pivot Jamb (#1)
Step 2 Installing the Adjustable
Pivot Jamb
Note: If your shower enclosure has a curve in the
corners at the side walls, be sure to measure the
distance from wall to wall ABOVE the curves.
A. Using the tape measure, find the center of the
shower sill. Make a mark where the center is on
both ends of the sill (See Figure 2).
Shower Sill
Sill Centerline
Figure 2
Sill Centerline
B. Locate the Adjustable Pivot Jamb, the
Adjustable Pivot Jamb Brackets and six #8 x 5/16”
PH SMS Screws.
C. Secure the Adjustable Pivot Jamb Brackets to
the Adjustable Pivot Jamb with the #8 x 5/16” PH
SMS Screws. Tighten the bottom three screws
completely. Tighten the top three screws only
half way.
D. Locate the Pivot Bushing (Bottom) and press it
into the Adjustable Pivot Jamb Bracket (Bottom)
plate hole (See Figure 3 for Model 650, Figure 3a for
Model 660).