Use Instructions

REGULATORY LABELING REQUIREMENTS

This system is equipped with an RF transmitter for wireless communications.

Each component has an RF identification number registered with the following regulating

agency:

Federal Communications Commission: FCC ID: SVHBAROSTIMIPG1 (all IPGs)

Federal Communications Commission: FCC ID: SVHBAROSTIMPGM1 (Model 9010

Programmer System)

Federal Communications Commission: FCC ID: SVHBAROSTIMPGM2 (Model 9020

Programmer System)

STATEMENT OF FEDERAL COMMUNICATIONS COMMISSION

(FCC) COMPLIANCE:

This device complies with Title 47, Part 15 of the FCC rules. Operation is subject to the

following two conditions:

• This device may not cause harmful interference, and

• This device must accept any interference received, including interference that

may cause undesired operation.

This transmitter is authorized by rule under the Medical Device Radio communication

Service (in part 95 of the FCC Rules) and must not cause harmful interference to stations

operating in the 400.150–406.000 MHz band in the Meteorological Aids (i.e., transmitters

and receivers used to communicate weather data), the Meteorological Satellite, or the

Earth Exploration Satellite Services and must accept interference that may be caused by

such stations, including interference that may cause undesired operation. This transmitter

shall be used only in accordance with the FCC Rules governing the Medical Device Radio

Communication Service.

Analog and digital voice communications are prohibited. Although this transmitter has

been approved by the Federal Communications Commission, there is no guarantee that it

will not receive interference or that any particular transmission from this transmitter will

be free from interference.