User guide

Figure 4–16 Removing a Drive Carrier Module (step 3)
Enclosure User Guide
66
4.14.2 Installing a Drive Carrier Module
Warning All drive bays must be fitted with Drive Carrier modules or Dummy Carrier modules to maintain a
balanced air flow.
4.14.2.1 Drive Carrier Configuration
Important Before you install the drive carrier modules in your FC60SS enclosure, please refer to
Section
2.2 on page 19 for system configuration information.
4.14.3 Installation Procedure
Important Ensure that the carrier is orientated so that the drive is uppermost and the handle opens from the
left.
1 Release the carrier handle, by pressing the latch in the handle towards the right (Figure 4–17) and insert
the carrier into the enclosure.