User guide

Troubleshooting
65
4.13 Removing/Replacing Disk I/O
Modules
To remove/replace a Disk I/O module, please follow the procedures for Removing and Replacing a
FC60SS RAID Module as defined in sections
4.11.1 on page 60 and 4.11.2 on page 62.
4.14 Drive Carrier Module
Warning Observe all conventional ESD precautions when handling FC60SS modules and
components. Avoid contact with backplane components and module connectors, etc.
4.14.1 Removing a Drive Carrier Module
Caution Drive spin down
Damage can occur to a drive if it is removed while still spinning, we recommend that you perform All steps
of the following procedure to ensure that the drive has stopped prior to removal:
1 Release the carrier handle, by pressing the latch in the handle towards the right (Figure 4–15).
Note The anti-tamper lock must be off.
Figure 4–15 Removing a Drive Carrier Module (step 1)
2 Gently withdraw the Drive Carrier module approximately 1 inch (25mm) and wait 30 seconds.
3 Withdraw the module from the drive bay (Figure 4–16).