User guide

Enclosure User Guide
60
4.10.2 Installing a Cooling Module
1 Check for damage, especially to the rear connector on the supply.
Caution Handle the module carefully and avoid damaging the connector pins. Do not install the module if any pins
appear to be bent.
2 With the latch in the open position (see Figure 4–5), slide the module into the enclosure until the latch
engages automatically (see Figure 4–7).
3 Cam the module home by manually closing the latch.(Figure 4–5). A click should be heard as the module
latches engage.
Figure 4–7 Cooling Module Installation
4.11 FC60SS RAID Module
Caution If only one FC60SS RAID module is fitted then a Blank module MUST be fitted in the unused slot, there
will be inadequate drive cooling if the slot is left open.
The following procedures apply to both the FC60SS RAID module and the Blank (FC60SS) module.
4.11.1 Removing an FC60SS RAID Module
Warning Do not remove this module unless a replacement can be immediately added. The system must not
be run without all modules in place.
1 Using two hands, grasp each latch between the thumb and forefinger of each hand. Squeeze thumb and
forefinger together to release the latch.