User guide

Getting Started
39
If you wish to manually configure your network setting, enter the correction information in the appropriate
fields.
Enter a new” password and confirm the new password. Click the Configure button.
Figure 2–20 Configuration Screen
6 if you have additional uninitialized embedded modules, select the next MAC address and choose the
appropriate settings from the previous step.
Once you have completed configuring all the uninitialized embedded modules and have clicked the
Configure button, the wizard will display a popup message indicating all systems have beenconfigured.It
will then re-scan for systems and if none are found, you will be taken to the Initialized screen.
If someone plugs in a uninitialized module system to the network (same subnet mask) during the time of
the rescan or resets a system’s password back to the defaults, you will be taken to the Uninitialized
screen again.
7 Select the MAC address of the embedded module you wish to start and click the Launch StorView
button. (
Figure 2–21)