User guide

Getting Started
27
• Menu-based RAID Configuration Utility User Guide .
2.5.3 RAID Configuration Utility (Text-based)
The FC60SS RAID module firmware based programs are accessed through a VT-100 terminal using a
text-based RAID Configuration Utility interface.
Please refer to the following document:
• Text-based RAID Configuration Utility User Guide
2.6 Enclosure Configuration
FC60SS enclosures are configured with one internal domain of 12 drives per FC60SS RAID
module.
2.7 Fibre Channel Interface
The FC60SS RAID module provides two Fibre Channel SFP interface connections.
The FC60SS RAID module provides bi-directional connection between the Fibre Channel host side
interface and the drives.The drives will not be presented to the Host until they are configured and mapped
by the controller.
Note There are no external terminators required with Fibre Channel architecture and any drive may be hot
plugged during operation.
Each FC60SS RAID module can be connected to up to 2 independent Host Bus Adaptors or switch ports.
Some typical configurations utilizing two FC60SS RAID modules and either one or two HBAs are shown
in Figure 2–7 to Figure 2–13 inclusive:
Important Optical modules must be UL (or other North American NRTL) RECOGNISED COMPONENT and the
laser in the module must comply with Laser Class 1, US 21 CFR (J) and EN 60825-1.
Please contact your supplier for a list of qualified optical SFP components.