User guide

Enclosure User Guide
26
4 If in doubt about correct orientation, the Operator’s Panel should be on the left hand side of the enclosure.
5 Tighten the two mounting thumbscrews present on each chassis flange.
2.4 Module Installation
The FC60SS enclosure is supplied fully populated with all plug-in modules installed. For
information on removal/replacement of plug-in modules, please refer to
Chapter 4. , ”Troubleshooting
and Problem Solving”, on page 47
2.5 Management Interfaces
The following management interfaces are provided and used to configure, manage and monitor the
FC60SS RAID Module Storage Solution.
2.5.1 StorView ® Storage Management Software
StorView ® Storage Management software is a full-featured graphical HTML-based software suite
designed to configure, manage and monitor the FC60SS RAID Module Storage Solution.
StorView provides the centralized local and remote management tool to control primary storage assets
vital to ensuring maximum data reliability, network up-time, and system serviceability. It also allows you
to manage and monitor the storage system from a host running StorView locally and from a web browser
across the intranet or internet.
StorView comprises the StorView Server which runs as a background service and is responsible for
managing the installed modules.
The StorView Server discovers system storage devices, manages and distributes message logs, and
communicates with other StorView Servers installed on the same local and external subnet networks.
A GUI provides the interface in an HTML-based front end which is accessed using a web browser.
The software incorporates a web server, Apache 2.0, that provides the interface between the StorView
Server and GUI. During installation the web server is automatically configured.
Please refer to the following documents:
• StorView Storage Manager Software Installation Guide
• StorView Storage Manager Software RAID Module User Guide
2.5.2 RAID Configuration Utility (Menu-based)
The FC60SS RAID module firmware based programs are accessed through a VT-100 terminal using a
menu-based RAID Configuration Utility interface.
Please refer to the following document: