User guide

Getting Started
25
4 Mount the enclosure in the rack as follows (refer to Figure 2–6):
a Lift the enclosure and align it with the rack rails.
b Carefully insert the chassis slides into the rack rails and push fully home.
c Tighten the rear screws.
d Withdraw the enclosure until it reaches the hard stops (approximately 400mm).
e Return the enclosure to the fully home position and attach to the rack using the captive fasteners
on the front flanges.
Figure 2–6 Mounting the Enclosure into a Rack (step 4)
2.3.5 Chassis Installation
2.3.5.1 Parts Check List
• Chassis (complete with Backplane, Ops Panel and all plug-in modules installed).
• Rack mounting thumbscrews (4 off).
2.3.5.2 Procedure
1 Fit the Rack Mounting Rail Kit in accordance with the mounting kit Installation procedure.
2 Check chassis for damage.
3 Slide the chassis assembly onto the rack rails until the front flanges engage on the rack. Ensure the
chassis is centrally located.