User guide

Figure 2–4 Securing Chassis Slides to Enclosure (steps 1 & 2)
Enclosure User Guide
24
3 Assemble to brackets (not handed) to rack as follows (refer to Figure 2–5):
a Locate the location pin at the rear of the rail into the rear rail post.
b Extend the rail to fit between the front and rear rack posts.
c Attach to both front and rear of the rack using the washers and screws supplied The screws
should be left loose enough to allow for sideways movement of the rail.
d Tighten the two clamping screws.
Figure 2–5 Securing Brackets to Rack - left hand assembly (step 3)