User guide

Figure 2–2 Unpacking the Enclosure System
Enclosure User Guide
22
2.3.3 Rack Installation Pre-Requisites
The FC60SS enclosure is designed for installation into an industry standard 19 inch cabinet
capable of holding the unit.
• Minimum depth 700 mm from front flange to rear metalwork (excludes rear cabling).
• Weight: up to 32kg dependent upon configuration per enclosure.
• A minimum gap of 25mm (1inch) clearance between the rack cover and front of drawer; and 50mm
(2 inches) rear clearance between rear of drawer and rear of rack is recommended in order to
maintain the correct air flow around the enclosure.
• The rack should present a maximum back pressure of 5 pascals (0.5mm water gauge).
2.3.3.1 Rack Mounting Rail Kit
A set of mounting rails is available for use in 19 inch rack cabinets (Figure 2–3). These rails have been
designed and tested to handle the maximum enclosure weight and to ensure that multiple FC60SS
enclosures may be installed without loss of space within the rack. Use of other mounting hardware may
cause some loss of rack space.