Material Safety Data Sheet

MAG AMP [1]
Date of last revision: 2/8/2008
Page 5 of 5
SECTION 14: TRANSPORT INFORMATION
DOT Classification: Not a DOT controlled material in the United States of America.
Identification: Not available
Special provisions for transport: Keep containers closed and keep from freezing.
Do not store above 100° F.
SECTION 15: REGULATORY INFORMATION
Federal and State Regulations:
While this material is not considered hazardous by the OSHA Hazard Communication Standard (29 CFR
1910.2000), this MSDS contains important information critical to the safe handling and correct usage of the
product. This MSDS is intended for use by employees and other users of the product and should not be
discarded.
California Safe Drinking Water and Toxic Enforcement Act of 1986:
This product contains the following ingredients known to the State of California
to cause birth defects, cancer, or other reproductive harm and require a warning
under the statute: NO products were found.
TSCA: All ingredients are on the inventory or exempt from listing.
SARA Title III Rules
Section 313 Toxic Chemicals: None
Section 302 EHS: None
International Regulations: This product is not currently sold outside the continental United States
of America.
WHIMS: Not Applicable
EINECS: Not Applicable
METI: Not Applicable
KECL: Not Applicable
AICS: Not Applicable
Note to the reader
This Material Safety Data Sheet is applicable only to the material as packaged. This product contains chemicals and
all chemicals may pose unknown hazards and should be used with utmost caution. The information and
recommendations contained herein are represented to be in good faith, and believed to be as accurate as possible
within the current version of this Material Safety Data Sheet (MSDS). If this product is mixed with any other
materials and/or chemicals, deteriorates, or becomes contaminated with microbiological or chemical agents, it may
pose hazards not listed or discussed in this MSDS. It is the end users responsibility to insure proper procedures are
developed and adhered to when utilizing this product. This includes utilizing proper personal protection equipment,
proper handling, and usage protocols based on the end users actual usage of the product. While his MSDS is based on
technical data determined to be accurate, and created in good faith, CES assumes no responsibility for the
completeness or accuracy of the information contained herein. Cutting Edge Solutions, LLC (CES) makes no
representation as to the completeness or accuracy of this MSDS. In no event will CES or the seller be liable for
consequential, incidental, special, exemplary, or indirect damages resulting from the use of this MSDS.
FINAL PAGE MAG-AMPED MSDS