Specifications

Detailed instructions for cleaning the filters are included in

the filter recharger kit.

CYLINDER HEAD

Now remove the carburetor compartment cover by first

oosening the two screws, A & B (Fig. 35). Then loosen the

one cylinder head cover screw, C. Remove the cylinder

head cover (Fig. 35). Check the cooling fins on the cylinder

and the fins on the flywheel for excess buildup of debris. If

necessary, clean with compressed air or solvent.

Fig. 35.

The top

cover.

NOTE

If you use solvent to clean around the clutch and

drive sprocket area, inject two or three pumps of

grease into the hole at the end of the crankshaft to

lubricate the bearings.

REASSEMBLY

OPERATION & MAINTENANCE / 21

Once you have completed this process, you have a clean

saw and are ready to reassemble it for continued use. The

reassembly is the same procedure as set-up, with the fol-

owing exception:

Flip the guide bar each time you reassemble the saw (Fig.

36). This provides for even wear. Reference the logo posi-

tion each time bar is flipped.

Fig. 36. Flip the guide bar each time you reassemble.

For specific engine adjustments and settings, consult the

accompanying chainsaw operations manual.

THINK!

IS WHAT

M ABOUT TO DO SAFE?

Read and follow all instructions for the proper set-

up, operation and maintenance of your Cutters

Edge Fire Rescue Saw. Be alert while using your

saw, and always strictly observe all safety

procedures.

Cutters Edge Fire Rescue Saws are designed specifically

for fire department use and are exceptional tools. However

-as with all tools-they have their limitations. With proper

care and, especially, common sense, your Cutters Edge

Fire Rescue Saw will give you many years of outstanding

performance and reliability.

you should have questions about the operation and/or

maintenance of your Cutters Edge Fire Rescue Saw, call

our service department at 1-800-433-3716.