Specifications

20 /CUTTERS EDGE FIRE RESCUE SAWS

NOTE

Your Titanium Rollemose guide bar has a sealed

bearing in the nose and no lubrication is

necessary.

THE POWER HEAD

Now inspect and clean the power head.

Wipe all debris and foreign matter from the power head,

making sure to clean carefully around the clutch.

Make sure the oil slot on the power head is clear and open.

Use a bar cleaning tool or small screwdriver to remove any

debris from this slot (Fig. 33).

Fig. 33. Carefully clean out the oil slot.

THE FILTERS

Next, remove the foam pre-filter from the saw (Fig. 34).

Spray it liberally with the filter cleaner/degreaser provided

with your saw. Work it in.

Rinse the pre-filter with clean water and allow it to air dry.

You should clean the main filter element only if the red color

s gone, or if you notice diminished power while running the

saw.

Fig. 34. Remove the pre-filter.

Remove the main filter element by loosening the filter clamp

screw. Pull out the choke to close the butterfly. This will pre-

vent foreign objects from entering the carburetor after you

have removed the filter.

f it needs cleaning, spray filter cleaner/degreaser around

the interior of the filter, creating a puddle. Rotate the filter to

distribute this evenly. Repeat with the exterior of the filter.

Next, rinse the filter thoroughly with water and allow to air

dry.

Do not use solvents to clean, or compressed air

to dry the filter as this may damage the filter

element.

Once thoroughly dry, spray filter oil only around the exterior

of the filter. Do not spray filter oil inside the filter.

NOTE

t is a good idea to have a spare filter. Drying time

can be over an hour and the extra filter can get

your saw back in service faster.

WARNING