Technical information

Nikon D200, D2HS, D2X and D2XS and Fuji S5 Pro are registered
trademarks or a trademark of their respective companies.
GeoPic II user settings
16
Setting: Option: Description:
1 Enabled
1 Beep
2 Disabled
Enables the beep in low power
and freeze modes.
1 1 min
2 2 mins
3 5 mins
4 10 mins
2 Auto off
5 Disabled
Enables the auto power down
after the period of inactivity
chosen.
1 Enabled
3 Button
†
2 Disabled
If enabled, the function button
will power up the GeoPic II.
1 Enabled
4 Meter
†
2 Disabled
If enabled, the GeoPic II powers
up when camera wakes up.
1 Enabled
5 Blink
2 Disabled
Enables the green/blue blink in
low power and freeze modes.
1 Enabled
6 Continuous
2 Disabled
Enables continuous sending of
GPS data in freeze mode.
1 Enabled
7 Alt. Field
2 Disabled
If enabled, in freeze mode the
altitude field is set to 99999m.
1 Enabled
8
Search
2 Disabled
Enables searching on power up
in freeze mode.
†
If setting 3 is disabled then setting 4 will be automatically enabled and vice
versa - this is to avoid a situation where it is not possible to turn on the unit.
Changing the settings is easy once you get used to it –
try going through the following example, which shows
how to change the Auto off setting (setting 2) to 10
minutes (option 4):
1) Press and hold the shutter release button half way
then press the function button for around 5 seconds to
enter program mode. Two white flashes confirm that
program mode has been entered and the following
single blue flash shows you that setting 1 is selected.