Enforcer 7 Direct Drive Manual

15
2. Nose piece continued – Remove the front nerf
bar and install the nose piece as shown. Mark
the location of the 3 holes on each side and
then drill with a .125 drill.
The optional low downforce nose piece can
also be prepared in a similar manner.
3. Side panels – install side panels on the cage
(you will have to remove some of the screws
already installed). Trim the side panels to clear
the rear shock tower as shown. The left side
panel will also need trimmed to clear the
motor.
4. Headers – trim headers and drill (2) .125
mounting holes on each. Mount as shown.
5. Tail tank – drill a ¼” hole just behind the
fuel fill area as shown. Trim the tank to clear
the shock tower.