User`s manual

2-1
CFT-A
Scanner Configuration
Introduction
The Custom Sensors CCD8000 Series scanners can be configured by scanning the
barcodes in this manual. There are four special barcodes that are used in the configuration
process. These are the Start, End, Abort and Set codes. These codes appear at the top of
every even page so that they are readily available at any point in the configuration process.
Their function is as follows:
The START code begins the configuration process. It signals the scanner that the
Configuration Mode is being entered and that barcodes it will be reading are the
barcodes in this manual.
The ABORT code signals the scanner to disregard any configuration changes made
since the START code was scanned, as long as the END code has not been
scanned. In effect, it ends the Configuration process with no changes made. To start
again scan the START code.
The END code ends the Configuration process and returns the scanner too its
normal operating mode.
The SET code sets all scanner parameters to their default values. Unless the scan-
ner was ordered with a special configuration, this resets the scanner to the configu-
ration it contained when it was received. Notice that each parameter listed in this
manual has a default value. This code can be scanned at any time. The START
code does not have to be scanned first.
The Default Configuration is as Follows:
Keyboard Wedge Interface
IBM PC/AT and PS/2 series Computers
US Keyboard Layout
Code 39, Codabar and EAN/UPC codes enabled
Read Mode: Trigger on/Good Read off
Good Read beep active
Keyboard number keys: alphanumeric
Preamble and Postamble: None
Each of the above parameters will be explained in the following Sections of this Manual.