User`s manual

START

END

ABORT

SET

2-16

CFT-A

END

START

BORT

SET

pressed as a Hexadecimal number, rather than decimal. Turn to the table in appendix A to

convert the desired length to a Hexadecimal number. For example, for a length of 10, the

Hexadecimal number would be 0A. Next, turn to Appendix C. Scan the barcode for 0, then

the code for A. Make sure to only scan each code once. If an error occurs, scan the Abort

code above, and restart. Scan the Set code in Appendix C. Scan the End code at the top of

any page.

Transmit Check Digit

Yes

Verify Check Digit

Yes No

Define Length

Specific Codabar Parameters

For the Codabar code type, there can be various sets of start and stop characters. In some

applications, the value of the start and stop characters are just as important at the barcode

data itself. Transmission of the start and stop characters, as well as the character sets

used, can be programmed by scanning the barcodes below.

Transmit Start and Stop Characters

Yes NO

Start / Stop Character set.

BCD / ABCD

BCD / TN*E

abcd / abcd abcd / tn*e