User`s manual

START
END
ABORT
SET
2-8
CFT-A
END
START
A
BORT
SET
Trigger On / Good Read Off - The trigger switch controls the start of the reading process.
When the trigger is pressed, the light source is turned on. When a good read is achieved,
the light is turned off and the data is transmitted. If a read has not been made within 3
seconds, the light is turned off and no transmission is made. This is the default mode of
operation.
Trigger ON
Direct Trigger Control - The light source is turned on and the scanner is enabled to read by
pressing the trigger switch. The trigger must be released and pressed again to end the
reading process.
Direct Trigger Contr
o
Always On - Pressing the trigger switch will turn the light source on and start the reading
process. Once a code is read, a different code must be seen ( or the same code removed
from the scanners view) before another read will occur.
A
lways On
Always On Continuous reading - Pressing the trigger switch will turn the light source on and
start the reading process. The scanner will output data every time it successfully decodes a
barcode.
Continuous Readin
g