User`s manual

START
END
ABORT
SET
2-6
CFT-A
END
START
A
BORT
SET
General Parameters
This Section sets some general configuration parameters that are independent of the type
of interface being used.
Select a Terminator Character(s) to be used in the data transmission. The terminator is
always transmitted last and indicates the end of transmission. In RS-232 a CR (Carriage
Return) is most often used. With the keyboard wedge interface, a TAB is often used to
send the cursor to the next data field.
An ID Character can be assigned to each code type. ID characters are used in situations
where the scanner may be reading several barcode types and it is desired to know which
type was read. A single ID character, which can be any ASCII character, can be assigned
to any or all code types. The character will be transmitted, immediately preceding the
barcode data, as part of the keyboard wedge or RS-232 transmission. To assign a charac-
ter, scan START and then scan one of the codes below that corresponds to the code type
to which the identifier will be assigned. Next, turn to the Appendix B Find the Hex value of
the identifier character. Then turn to Appendix C and scan the barcodes for the two num-
bers of the Hex value. Scan the Set code in Appendix C. Scan the END Code at the top of
any page.
CR (Default)
LF (RS-232 Only)
CR/LF (RS-232 Onl
y
Space
Tab
Esc
Ctrl-C
Code 39 Industrial 2 of 5
Matrix 2 of 5
Codabar
UPC-A/EAN-13
EAN-8
UPC-E
None
Interleaved 2 of 5